CutWatt · energy optimization
Stop wasting energy
Start saving money
CutWatt uncovers hidden energy waste, optimizes your operations, and delivers measurable, long-term savings
Step 1 · Cold store
Heat leaks in all day
Door openings, warm panels and worn seals add load the plant must remove
Step 2 · Compressor
The biggest electrical load
Often most of a cold store's power — it runs hot when poorly staged
Step 3 · Condenser
Where the heat goes outside
Fouled coils and fixed fan speeds make the compressor work harder
Step 4 · Evaporator
Where the cold is made
Coils and fans pull heat out of the room — frost and poor defrost cut capacity
Step 5 · Measure
Every kilowatt-hour, per load
Non-invasive CT clamps on the incomer and the big feeders turn one monthly number into a curve you can read, at 1-minute resolution — no shutdown, no rewiring
Site figures · illustrative
Step 6 · See
Heat is the receipt
Thermal imaging of panels, motors and terminations, ranked by the cost of inaction — a loose termination shows up as heat long before it fails
What you seePainted pipes on a ceiling
What the camera seesA 22 °C gradient bleeding into the room
Step 7 · Lens
Point, read, believe
To the eye, a motor-control panel is a grey box — through a radiometric lens every pixel is a temperature: terminal lug 81.3 °C, cable bundle 51.2 °C, control wiring 31.7 °C
Step 7 · Lens · Isolate
Draw the line at any temperature
An isotherm turns a picture into a list — drag the threshold and everything above it lights up
- Surface above threshold
- 0%
- Flagged points
- 0 of 3
Real panel scan, temperatures read from the camera scale · before correction
Step 7 · Lens · Re-scan
The same panel, after the fix
Re-torqued terminations and a rebalanced load — scroll and watch the hot spot cool
- Terminal lug
- 81.3 °C
- Cable bundle
- 51.2 °C
- Control wiring
- 31.7 °C
- Compressor starts
- 9 → 3 /h
After-fix figures are illustrative
Step 8 · Correct
Fix settings, not budgets
Compressor starts fall from 9 to 3 per hour — head pressure floats with the weather — defrost runs on demand, not on a clock
Anonymised case studies · illustrative
Estimate · 30 seconds
Four questions — the answer appears immediately - you decide afterwards whether you want us to verify it on site
Which of these are true?
Enter your monthly bill to see an estimate
- Share of your bill that is waste
- 0%
- Per month
- AED 0
- Over five years
- AED 0
Indicative only — built from assumed ranges, not from your data — a site assessment replaces it with measured numbers
Free first assessment
Find out what your site is wasting
Leave a number and your company — we spend twenty minutes on a call working out whether there is enough on the table to justify a site visit, and tell you if there is not